Nitrous Express ELECTRONIC FUEL INJECTED 5.0 COYOTE PLATE SYSTEM - Manual (Page 3)

3
MOUNTING THE NITROUS PLATE
Before any modifications are made under the hood, we suggest that you make a diagram of all hoses wiring and
linkages.
1. Pre-assemble the nitrous plate before you begin. Select the horsepower setting that you want to start with, insert
the proper nitrous jet in the fitting marked “N2O” (CAUTION: You must always use a back-up wrench when
tightening the nitrous or fuel fittings, failure to do so will void the system warranty!!!!!) Connect the blue
stainless main feed line to the plate fitting. The nitrous fitting can be identified by the “N2O” marked on the top
of the plate. Repeat this procedure for the fuel solenoid (the fuel fitting will be marked “FUEL”). NOTE: Always
check each jet for obstructions before using.
2. Remove the throttle body.
3. The nitrous plate should be installed as shown. (See Illustration B) Fuel and nitrous fittings are to the rear. Using
supplied O-ring gasket reinstall the throttle body in front of the nitrous plate and torque to factory specs using the
provided hardware.
ILLUSTRATION B