ididit Column Add-Ons: Aluminum Cruise Control Cover - Manual (Page 2)

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Instruction #: 8000010100 REV 01/14
Aluminum Cruise Control Cover Installation Instructions Cont.
For Part Number’s 2501000030, 2501000040
If the column is a Tilt & Telescopic follow
these steps:
1. Remove the locking lever or ring of the
telescoping feature. Remove the wheel assembly
(7/8 socket). Note: If you have an ididit column,
mark the adaptor to the shaft for alignment when
re-assembling.
2. Remove the current lever. Note: if this is already a
cruise, install a pull wire to retrieve the wire back
through (we reccomend florist wire).
3. Install the cruise cover on lever (follow the
instruction on the previous page.)
4. Feed the wire through the lever hole and into the
column.
5. There is an access hole through our column head
assembly. Look for this at about 7:00 just below
the turn signal lever. This channel leads through
the castings and into the tube of the column (this
includes GM columns).
6. Feed a piece of florist wire down through this hole
and out the wire exit hole where the rest of the
wires exit. We reccomend that you remove the
wire grommet to be able to see when you get there.
7. Once you pull the wire through, tape the 4 wires in
a square with the pull wire in the middle and loop
the pull wire so it cannot pull out.
8. Wiggle the wire bundle gently down through the
column. If this gets caught about 5 inches in, then
turn the wires while pushing and pulling with the
other hand. This normally lets them slide in a little
easier.
9. Replace the plastic plug by putting the pins back into
the original holes. Refer to the color code on the plug.
10. Hook up the rest of the cruise control system and
replace your steering wheel.