ididit Column Add-Ons: Aluminum Cruise Control Cover - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Aluminum Cruise Control Cover Installation Instructions
For Part Number’s 2501000030, 2501000040
Instruction #: 8000010100 REV 01/14
1. Remove the white plastic plug from the wires by
using a small screwdriver or electrical tool to
depress the locking tab on the pins.
(Figure 1)
Remove the four pins from the connector. There
are letters on one side of the plug which coincide
with the colors of the wires. (B=Brown, R=Red,
Y=Yellow, G=Green)
(Figure 2)
2. Using a thin pocketknife, gently pry the slide-switch
up and out of the cruise handle. (Figure 3) Set the
slide-switch to the side.
3. Wrap the loose wires in tape so they can easily
slide through the lever hole. (Figure 4) With the
large end first, slide the Aluminum Cruise Cover
up the wires and onto the handle. You may have
to use a little force to get the wires from the lever
into the cover. Align cover so that it centers on the
slide-switch area and press it on. These items both
have a taper on them and should lock in place with a
firm tap against the palm. (If not add 1 rap of scotch
tape to tapered area on the plastic knob).
(Figure 5)
Replace the slide-switch by simply pressing it into
its lock down mechanism.
(Figure 6) Your cover
is now installed. (Figure 7)
If the steering column is a Tilt or Non-Tilt follow
these steps:
1. Remove the steering wheel and replace the turn
signal lever with the cruise lever. Using a florist
wire, feed the wires from the cruise handle through
the turn signal hole of the column sleeve. The access
hole for this is about 5/8” round and at 7:00. Feed
the pull wire down and back out of the exit hole.
Then attach the cruise wires and pull the wires with
this leader.
2. Replace the plastic plug by putting the pins back
into the original holes. Refer to the color code on
the plug.
3. Hook up the rest of the cruise control system and
replace your steering wheel.
If your column is
Tilt & Telescopic