ididit Right Hand Drive & Collapsible Steering Column: RHD 1968-69 Mustang - Manual (Page 8)

ididit,
inc.
610 S. Maumee St., Tecumseh, MI 49286
(517) 424-0577 • (517) 424-7293 fax
www.ididitinc.com
No part of this guide may be reprinted, reproduced or utilized in any form without the express written
permission of ididit, inc.
2010 ididit, inc.
All Rights Reserved
Printed in the USA
After removing all items from the package,
assemble the knobs onto the levers. The tilt
lever (shorter of the two levers) goes on the
right side of the column in the hole closest to
the dash. The column has a threaded hole that
this lever threads into. (Figure 6)
The turn signal lever (longer of the two le-
vers) goes on the right side of the column in
the hole closest to the driver. The column has
a threaded hole that this lever threads into.
(Figure 7)
Your 4-Way flasher knob is installed when
the column is put together.
Knobs & Levers:
(Figure 6)
(Figure 7)
Steering Wheel:
OEM Wheel - Must be for the same year
application as the column. *Use of a
different year of wheel will result in damage
to the turn signal switch.*
Aim the road wheels so they are pointing straight
ahead. Lower the stock steering wheel onto the col-
umn and center it in its proper position. Tighten the
NEW nut that came with the column to 45 ft lbs. You
may need to adjust the wheel a bit after driving the
vehicle to get the wheel just where you want it. Re-
install the horn and spring by pushing in and turning
clockwise to lock it into place.
Hook the battery back-up and verify that your signals, brake lights, etc are operat-
ing properly. Double check all fasteners including coupler, dash mount and floor
mount to make sure they are all tight.