Steering wheel, Ididit – ididit Retrofit Steering Column: 1965 Mercury Comet User Manual
Page 8

6
STEERING WHEEL
This column has a Ford top shaft and will accept your stock 1965 Comet
steering wheel.
Before installing your steering wheel, apply dielectric grease on the horn pins
on the column and on the steering wheel grooves they ride in. When you put
your wheel on, make sure the pins are collapsing straight and not being bent
over.
Aim the road wheels so they are pointing straight ahead. Lower the stock
steering wheel onto the column and center it in its proper position. Tighten the
NEW nut that came with the column to 35 ft lbs. You may need to adjust the
wheel a bit after driving the vehicle to get the wheel just where you want it.
Re-install the horn and spring by pushing in and turning clockwise to lock it
into place.
Hook the battery back-up and verify that your signals, brake lights, etc are
operating properly. Double check all fasteners including coupler, dash mount
and floor mount to make sure they are all tight.
Need Further Assistance?
ididit, inc has been serving the rodding community for over 25 years and we
take pride in our outstanding customer service. If you need further assistance,
feel free to call us at (517) 424-0577, Monday-Friday from 8:30 am - 5:30 pm
and Saturday 10:00 am - 2 pm EST. You can also email us at tech@ididitinc.
com.
No part of this guide may be reprinted, reproduced or utilized in
any form without the express written permission of ididit, inc.
2013 ididit, inc.
All Rights Reserved
Printed in the USA
ididit,
inc.
610 S. Maumee St., Tecumseh, MI 49286
(517) 424-0577 • (517) 424-7293 fax
www.ididitinc.com