beautypg.com

Wiring installation – ididit Retrofit Steering Column: 1965 Mercury Comet User Manual

Page 6

background image

WIRING INSTALLATION

The first few tasks will be easier to do on a workbench before installing the
column in your car.

New male and female connectors with terminals
are included with your new ididit steering
column. You may use these new connectors
with your wiring or you can use the original
connectors. The terminal pins in the new
connectors are the same size as the original. If
you have an aftermarket harness these may be
helpful for a clean installation. (Figure 9)

If you are using the OEM connectors see the
diagram below for the correct color pin out on
your column. (Figure 10)

As mentioned previously, a ground wire was
attached to the original column. This would
be a good time to remove any paint or powder
coat for this ground wire to do its job.

Figure 9

Figure 10

4

TERMINAL SIDE

Steering column plugs