ididit Universal Steering Column: Universal Shorty Tilt - Manual (Page 4)

How to install your Tilt, Turn Signal Levers and Hazard Knob
Turn Signal Lever:
The signal lever is the lever closest to the top
of the column. With the steering wheel and
adaptor removed, look down from the top
of the column and you’ll see where a single
screw holds the signal lever in place. Insert
the new lever using the provided screw into
round hole (not D shaped hole). When install-
ing this lever in a new column, use the screw
supplied to fasten the lever in the recessed
area on the signal switch arm.
Tilt Lever:
Look directly below the turn signal lever, and
you’ll see another opening in the column. Inside
this opening is a threaded hole which the new lever
screws into.
Emergency Flasher Knob:
Almost directly opposite the turn lever on the steer-
ing column is another opening. Inside this opening
is a hole in the nylon switch. Simply screw the new
knob in place (clockwise). When completing in-
stallation of flasher knob make sure that the knob
is in the out (off), position so when finished wiring
you don’t have any complications.
If Column Shift Application:
Place column shift knob onto the shift lever. Once
your lever is on, use setscrew (provided) and ad-
just knob so set screw is not facing forward, tight-
en setscrew. Do not remove the upper shift lever
for any reason! The tension spring will pop out
and it is very difficult to re-install.
3