ididit Universal Steering Column: Universal Shorty Tilt - Manual (Page 3)

Universal Shorty Installation Instructions:
1. Affix your adjustable under dash
mount to the firewall and the dash. The
under dash mount part # is: 2301000010.
(Figure 1) A support may need to be
built behind the dash.
2. Attach the column to the mount with
two steering column drops. Long oval
holes have been provided to allow full
adjustability of the position of the drops.
The bigger the difference in length of
drops, the greater the angle of the column.
(Figure 2)
3. Install the Flange
Bearing to support
your steering shaft
as well as seal the
firewall. (Part #
MSD52130) Attach
the universal joint(s)
and shafting from the column to the
steering box. Most universal joints can
bend up to 35 degrees. If you need more
than 35 degrees but less than 70, a double
u-joint is required. A support bearing
is necessary for every u-joint over two
within the system. (Figure 3)
4. When using a column shift mount
the cable shift linkage to the base of the
column. Route the cable through the kick
panel to the transmission. (Figure 4)
Figure 1
Figure 2
Figure 3
Figure 4
2