FanAm MD60 AC Drive - Manual (Page 128)

G-4 MD60 AC Drive User Manual
Connecting Two Permanent Peripherals
Connecting an RS485 Network
Figure G.6 – Connecting Two Permanent Peripherals
M
S
NEMA 4
Panel Mount OIM
or
NEMA 1 Bezel
with Handheld OIM
MD60 Drive
or
Parameter 9 (Device Type) set to
"Master" and connected to Master
port (M) on RJ45 Splitter Cable
Parameter 9 (Device Type)
set to "Slave" and
connected to Slave port (S)
on RJ45 Splitter Cable
Figure G.7 – Connecting an RS485 Network
AK-U0-RJ45-TR1
Terminating Resistor
(end of network)
AK-U0-RJ45-TB2P
Two-position
Terminal Block
or
MD60 Drives
or
Customer-supplied RJ45 male-to-RJ45 male
cables with wires connected at pins 4 and 5 only.
Both the Master (M) and Slave (S) ports on the RJ45 Splitter
Cable operate as standard RS-485 ports in this configuration.
Sel Esc