American Fibertek Commander C10e/C10e-I/C10p/C10p-I - Manual (Page 83)

83
Switch Setup
Switch Flow
Switch setup are restricted to Master Admin, IT Admin and IT
Admin with Security View authorization settings. Further,
Switch Setups can only be view by Master and IT authorization
levels.
Security levels cannot setup or access Switch Setups
Warning: The following section contains network switch
setups. Improper set up can degrade and/or significantly
degrade switch performance. Please proceed only if you have
knowledge in this area.
Return to Default
Each Switch mode set up screen
as a return to default setting
which will return that individual
mode to it programmed default
setting without affecting other
settings
When Default is selected a pop up will appear asking
you to confirm your decision. Selecting OK will return
the screen to its default setting.
Disabled Port:
When a port is disabled its name will
appear in RED. You will still be allowed
to program most functions. When the
port is made active the programming
will be applied