American Fibertek Commander C10e/C10e-I/C10p/C10p-I - Manual (Page 100)

100
Reboot
Reboot Selection: It the event that Commander should stop operating or a new firmware update
applied, it can be remotely rebooted. If a reboot become necessary, click on the “Reboot” button
in the mode selection area.
Warning : Rebooting will cause all event data to be lost. Make certain you back up your
data on a regular basis.
Reboot Confirmation: A pop up will appear asking you to confirm you decision. Click OK to
confirm. Click Cancel to return to the previous Menu
After requesting a reboot a pop up will appear asking you to confirm your decision.
Notes on Reboot:
Under certain conditions you may not be able to reboot using the client and a hard reset maybe
come necessary.
Only the Master Admin has access to this reboot function.
Warning : Reboot will result in a loss of all data. Make certain that you back up your data on a
regular basis using the Save As function and or Email. Rebooting will not affect your
programming and after reboot Commander will return to its previously programmed operation.