AirSep MN171-1 - Manual (Page 16)

MN171-1 Rev. A 02/14
3.1.4.2 Charging the Optional AirBelt
To charge the AirBelt battery:
1) Release safetycap from end of the AirBelt cord.
2) Connect the AC/DC power supply (included with the AirBelt Accessory kit) to the end of
AirBelts power cord as shown in Figure 12.
3) Connect the AirBelt power supply to an AC electrical outlet to recharge.
Replace safety cap on AirBelt cord when not in use.
Do not attempt to charge the optional AirBelt with the Focus power supply or the AirBelt can be
damaged. Use only the AirBelt power supply provided to charge AirBelt.
•
The Focus AirBelt will completely recharge from its fully depleted state in approximately 3 ½ hours.
• While charging a fully discharged battery, the LED will continue to blink until 25% capacity is reached. The LED
will then turn solid.
• Each of the four LEDs, 25% -100%, will blink as stated above, then turn solid when the battery reaches it’s
capacity .
• When all LEDs illuminate solid, the battery is fully charged and the LEDs will remain solid for a period of time, then
all four LEDs will turn off.
The incorrect use of AirBelt can cause it to get hot, ignite, and may cause serious injury. Be sure not to
pierce, strike, step on, or drop the battery, or otherwise subject the battery to strong impacts or shocks.
Do not store Focus or AirBelt in a very hot automobile or in other similar, high- or low-temperature
environments. Operating or storing the AirBelt outside the normal temperature range can affect its
performance. (Refer to the Specifications section in this manual.)
Figure 12: AirBelt Battery Charging set up
F
i
g
u
r
e
4
AirBelt
PW009-2
AC/DC Power
Supply
F
i
g
u
r
e
4
AC/DC Power Supply
PW009-2 AC/DC Power Supply
F
i
g
u
r
e
4
Connecting the AirBelt cord to the power supply cord
PW009-2 AC/DC Power Supply
Figu
re 4