AirSep MN171-1 - Manual (Page 12)

MN171-1 Rev. A 02/14
2) Connecting Focus to a DC power source
The universal power supply can also be used to operate the Focus unit from any 12-Volt DC
power source.
For example: to an automobile, (boat, motor home, etc.) with a 12-Volt DC outlet.
Connect the power supply cord labeled DC OUT To Focus into the Focus unit’s power inlet, as
shown in Figure 3. Place the DC accessory adapter on the end of the DC power cord.
Connect the other end into the power supply input connection labeled Accessory DC IN
(see Figure 4).
You can then connect the DC power cord (with adapter attached) into the 12-Volt DC power
source. Do not force the cords, as they can be inserted only one way.
Turn the Focus unit on by pressing the power switch to the on position ( l).
Focus unit’s Power Inlet
DC OUT to Focus
F
i
g
u
r
e
4
Figure: 3
F
i
g
u
r
e
4
Connect to Focus
Accessory DC IN
Figure: 4
F
i
g
DC OUT to Focus
DC accessory adapter
DC power cord