GE ZV925SLSS - Manual (Page 7)

7
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and tape measure
Pliers
120V 60Hz. 15 or 20 Amp,
2-wire with ground. properly
grounded branch circuit.
Key hole saw
Wire cutter/stripper
Step ladder
Metal snips
Saber saw
or sawsall
Wire nuts
Phillips and
flat blade
screwdrivers
Strain relief for
junction cover.
Spirit level
Flashlight
Safety glasses 8" round metal
duct, length to
suit installation.
Duct tape
3/8" swivel
socket or pivoting
hex socket with 6"
extensions
Carpenter’s square
REMOVE THE PACKAGING
CAUTION:
LIFT THE HOOD OUT OF THE
BOX BY THE CENTER METAL PORTION. DO NOT LIFT
BY THE GLASS SIDES.
PRUDENCE :
LEVEZ LA HOTTE À
L’EXTÉRIEUR DE LA BOÎTE PAR LA PORTION MÉTAL
CENTRAL. NE LEVEZ PAS PAR LES CÔTÉS DE VERRE.
CAUTION:
Wear gloves to protect
against sharp edges.
PRUDENCE :
Portez des gants pour
éviter les blessures causées par les tranchants.
• Grasp the hood by the metal insert in the center
and lift straight up and out of the box.
• Remove and properly discard the plastic wrapping.
• Remove parts box, duct covers and other
packaging.
Hammer
Electric or battery-operated
drill and 3/16" bits, Phillips and
flat blade screwdriver bits.