HP 2120 Disk System - Manual (Page 14)

HP StorageWorks Disk System 2120 14
Keep in mind that the host bus adapter should have the highest SCSI address priority.
See Table 5 below.
TABLE 5 SCSI Address Priority
Installing the Disk System
See the installation instructions enclosed with your rackmount kit.
Connect the SCSI Cables
1 Make sure that the host system has been powered down.
2 Connect one end of an Ultra SCSI cable (included in the shipping box) to the host
system. For the SCSI port location on your host system, refer to your host system’s
documentation.
3 Connect the other end of the SCSI cable to one of the LVD/SE ports on the rear of
the disk system.
FIGURE 8 SCSI Port Locations
SCSI ID 7 6 5 4 3 2 1 0 15 14 13 12 11 10 9 8
Priority Highest Lowest
LVD/SE
SCSI
Port
LVD/SE
SCSI
Port