Displaying info output as commands – HP Integrity NonStop J-Series User Manual
Page 95

Changing Display Options
Safeguard User’s Guide — 422089-020
8 - 7
Displaying INFO Output as Commands
By default, the INFO report identifies users by their user IDs. To view user names
instead of user IDs, execute the following SAFECOM commands:
=DISPLAY USER AS NAME
=INFO DISKFILE quarter1
The display shows:
To return to the default setting of identifying users by their user IDs during this session:
=DISPLAY USER AS NUMBER
Displaying INFO Output as Commands
The DISPLAY AS COMMANDS command allows you to specify that the output of an
INFO command be displayed as SAFECOM commands rather than as a report.
DISPLAY AS COMMANDS has three forms:
For example, assume you execute the following INFO command at the start of a
SAFECOM session to display the authorization record for the disk file rpt01:
=INFO DISKFILE rpt01, DETAIL
LAST-MODIFIED OWNER STATUS WARNING-MODE
$DATA.SALES
QUARTER1 23JUL92, 15:00 ADMIN.BILL THAWED OFF
ADMIN.BILL R,W,E,P,C,O
ADMIN.LYNN R,W
ADMIN.* R
Note. If a report contains a deleted user, that user is identified by user ID even if you are
displaying users as user names.
DISPLAY AS COMMANDS
OFF
displays the output of an INFO command in report
form. This is the SAFECOM default setting.
DISPLAY AS COMMANDS ON
displays the output of an INFO command as
SAFECOM commands during the current session.
DISPLAY AS COMMANDS
displays the output of an INFO command as
SAFECOM commands during the current session.