HP Integrity NonStop J-Series - Manual (Page 40)

Securing Disk Files
Safeguard User’s Guide — 422089-020
3 - 6
Controlling Default Attributes
The display shows the default attributes for a disk file that are in effect when you start a
SAFECOM session. No access control list is defined.
You can change any of the default attributes at any time during the session, and the
changes remain in effect until you exit SAFECOM. The default attributes return to their
original state when you exit SAFECOM.
To change any of the default attributes, use the SET DISKFILE command. To set a
default access control list:
=SET DISKFILE ACCESS 2,1 (R,W,E,P) ; 2,* (R,E)
This access control list gives you READ, WRITE, EXECUTE, and PURGE authority
and gives all other users in group 2 READ and EXECUTE authority. Use the semicolon
(;) to separate access control list entries.
Enter:
=SHOW DISKFILE
The display shows:
The default attributes include an access control list. Any files you add to the Safeguard
database during this SAFECOM session will have this access control list unless you
specify otherwise. You can specify additional access control list entries when you add
files. See
Working With Access Control Lists .
To reset the default attributes to the original Safeguard defaults:
=RESET DISKFILE
The default attributes also assume their original values when you start SAFECOM.
TYPE OWNER WARNING-MODE
DISKFILE 2,1 OFF
OBJECT-TEXT-DESCRIPTION =
AUDIT-ACCESS-PASS = NONE AUDIT-MANAGE-PASS = NONE
AUDIT-ACCESS-FAIL = NONE AUDIT-MANAGE-FAIL = NONE
AUDIT-PRIV-LOGON = OFF
LICENSE = OFF PROGID = OFF CLEARONPURGE = OFF PERSISTENT = OFF
TRUST = OFF PRIV-LOGON = OFF
002,001 R,W,E,P
002,* R, E
Note. The attributes, AUDIT-PRIV-LOGON and PRIV-LOGON, are supported only on systems
running H06.11 and later H-series RVUs and G06.32 and later G-series RVUs. The OBJECT-
TEXT-DESCRIPTION attribute is supported only on systems running J06.05 and later J-series
RVUs and H06.16 and later H-series RVUs.