HP ProLiant SL230s Gen8 Server - Manual (Page 36)

Hardware options installation 36
DIMM type DIMM rank One processor Two processors
RDIMM
Single-rank 64GB 128 GB
RDIMM Dual-rank 128 GB 256 GB
UDIMM Single-rank 16 GB 32 GB
UDIMM Dual-rank 64 GB 128GB
LRDIMM Quad-rank 256 GB 512 GB
General DIMM slot population guidelines
Observe the following guidelines for all AMP modes:
• Install DIMMs only if the corresponding processor is installed.
• When two processors are installed, balance the DIMMs across the two processors.
• White DIMM slots denote the first slot of a channel (Ch 1-A, Ch 2-C, Ch 3-B, Ch 4-D).
• Do not mix RDIMMs or UDIMMs.
• When one processor is installed, install DIMMs in sequential alphabetic order: A, B, C, D, E, F, and so
forth.
• When two processors are installed, install the DIMMs in sequential alphabetic order balanced between
the two processors: P1-A, P2-A, P1-B, P2-B, P1-C, P2-C, and so forth.
• For DIMM spare replacement, install the DIMMs per slot number as instructed by the system software.
For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool
on the HP website ( http://www.hp.com/go/ddr3memory-configurator ).
The following DIMM speeds are supported in this server.
Populated slots (per
channel)
Rank Speeds supported
(MHz)*
Speeds supported (MHz)**
1 Single or dual 1066, 1333, 1600 1333, 1600, 1866
2 Single or dual 1066, 1333, 1600 1333, 1600, 1866
1 Quad - 1866
2
Quad - 1866
*Intel Xeon Processor E5-2600 series
**Intel Xeon Processor E5-2600 v2 series
Advanced ECC population guidelines
For Advanced ECC mode configurations, observe the following guidelines:
• Observe the general DIMM slot population guidelines (on page 36 ).
• DIMMs may be installed individually.
Online Spare population guidelines
For Online Spare memory mode configurations, observe the following guidelines:
• Observe the general DIMM slot population guidelines.