HP EliteBook 2570p Notebook PC - Manual (Page 62)

Removing or replacing the service cover
Removing the service cover
Remove the service cover to access the memory module slot, hard drive, regulatory label, and other
components.
1. Remove the battery (see Inserting or removing the battery on page 39 ).
2. Loosen and remove the service cover screw (1).
3. Slide the service cover release latch to the right (2) to release the service cover.
4. Remove the service cover by sliding the service cover out (3) and lifting it away from the
computer (4).
To replace the service cover, reverse this procedure.
Replacing or upgrading the hard drive
CAUTION: To prevent information loss or an unresponsive system:
Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the
hard drive while the computer is on, in the Sleep state, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.
Removing the hard drive
To remove a hard drive:
1. Save your work and shut down the computer.
2. Disconnect AC power and external devices connected to the computer.
52 Chapter 8 Drives