HP XP Racks - Manual (Page 8)

2 Requirements
This topic provides information about Auto LUN requirements.
System requirements
To perform Auto LUN operations using Remote Web Console or RAID Manager, you need:
•
A HP XP7 Storage system
•
A Remote Web Console computer
•
Performance Monitor
•
Auto LUN
To perform Auto LUN operations using Command View Advanced Edition Suite, you need:
•
A XP7 Storage system
•
A Remote Web Console computer
•
Either of the following:
Both Performance Monitor and Auto LUN ◦
◦ Auto LUN V2
If you install only Auto LUN V2, you cannot perform Auto LUN operation with Remote Web Console
and RAID Manager.
Source and target volume general requirements
The source and target volume should satisfy the following conditions:
•
Managed by the same storage system, even if the volumes are the external volumes.
•
Have the same emulation type and capacity. If the emulation type is not OPEN-V, both the
source and target volumes must be custom-sized (CV) volumes or normal volumes.
•
The LDEV IDs (LDKC:CU:LDEV) must have values between 00:00:00 and 00:FE:FF
•
Must be specified by LDEV ID, not VOLSER or TID/LUN.
•
Do not set Cache Residency on the migrating volume.
Volumes assigned to resource groups
When you use Resource Partition, you can create migration plans including volumes that belong
to resource groups as source volumes and target volumes. You may be unable to create migration
plans depending on the use of Resource Partition.
Table 1 Information about whether you can create migration plans when using Resource Partition
Resource groups where target volumes belong Resource groups where source
volumes belong
are not assigned to user groups where
you belong are assigned to user groups where you
belong
No Yes are assigned to user groups where
you belong
No No are not assigned to user groups where
you belong
Legend
Yes: You can create migration plans.
8 Requirements