HP XP Racks - Manual (Page 34)

Table 20 RAID Manager errors related to migration plans (continued)
Required Action Message Error Code
(SSB2)
Release the volume from Continuous Access
Journal, and then migrate the volume. The migration target volume is being used with
Continuous Access Journal. 2055
Release the volume from Continuous Access
Journal, and then migrate the volume. The migration source volume is being used with
Continuous Access Journal. 2056
The volume cannot be migrated. Check the
configuration definition file. The migration target volume and the migration
source volume belong to the same parity group. 2058
Release the volume from Continuous Access
Journal, and then migrate the volume. The migration target volume is being used with
Continuous Access Journal. 205C
The volume cannot be migrated. Check the
configuration definition file. The migration source volume corresponds to the
following cause: 2075
The volume is secondary volume of the Fast Snap
pair, or V-VOL of Fast Snap.
Perform the following actions for each cause: The migration target volume corresponds to either
of the following causes: 2076
1. Release the Fast Snap pair, and then migrate
the volume.
1. The volume is primary volume of the Fast Snap
pair.
2. None. This migration plan cannot be executed.
2. The volume is secondary volume of the Fast
Snap pair, or V-VOL of Fast Snap.
Release the pool-VOL setting of Fast Snap from the
volume, and then migrate the volume. The migration source volume is the pool-VOL of
Fast Snap. 2078
Release the pool-VOL setting of Fast Snap from the
volume, and then migrate the volume. The migration target volume is the pool-VOL of
Fast Snap. 2079
Wait for the quick formatting to complete and then
migrate the volume. The migration source volume is undergoing quick
formatting. 2089
Wait for the quick formatting to complete and then
migrate the volume. The migration target volume is undergoing quick
formatting. 208A
The volume cannot be migrated. Check the
configuration definition file. The migration source volume or the migration
target volume is a Mainframe Fibre Data Migration
volume. 208f
Associate the Thin Provisioning or Smart Tiers
virtual volume with a pool, and then migrate the
volume. The migration target volume is the Thin
Provisioning or Smart Tiers virtual volume which
is not associated with a pool. 2090
Associate the Thin Provisioning or Smart Tiers
virtual volume with a pool, and then migrate the
volume. The migration source volume is the Thin
Provisioning or Smart Tiers virtual volume which
is not associated with a pool. 2091
The volume cannot be migrated. Check the
configuration definition file. The migration source volume is primary volume of
the Fast Snap pair. 2093
The volume cannot be migrated. Check the
configuration definition file. The migration target volume and the migration
source volume are the Thin Provisioning or Smart 2095
Tiers virtual volumes that are associated with the
same pool.
Release the pair containing the migration source
volume, and then migrate the volume. The migration source volume is used by Continuous
Access Synchronous or Continuous Access Journal. 2096
The migration target volume is a Thin Provisioning
or Smart Tiers virtual volume.
Wait until the capacity increase is completed.
Then, you must specify a target volume which has The migration source volume is a Thin Provisioning
or Smart Tiers virtual volume whose capacity is
increasing. 20A5
the same capacity as the volume whose capacity
is increased and migrate the volume.
34 Using RAID Manager for Auto LUN