HP SmartStart-Software User Manual
Page 19
Advanced topics 19
Command-line
argument
Description
/tpmbypass or
/ignore_tpm
This argument specifies that if a Trusted Platform Module (TPM) is enabled,
then the warning message can be ignored and component installation
continues.
/use_wmi
This argument specifies that components, which use WMI protocol, are
available to be selected for installation. These components are optional by
default and will not be installed unless this argument is used. When the
/use_wmi argument is used, and the /use_snmp argument is not, the SNMP
components are optional.
/use_latest
This argument is a filter switch for use with bundles. The argument enables
you to use the latest version of the bundle when multiple versions of bundles
are listed on the command line. If there are no bundles specified on the
command line, and multiple bundles are in the directory, the /use_latest
argument enables HP SUM to use the bundle with the latest version for
installation.
/romonly
This argument is a filter switch and enables the user to view only the firmware
components needed for installation. When using this filter switch, you must
exit, and then restart HP SUM to return to an unfiltered state. Do not use the
/romonly argument with the /softwareonly argument.
Overriding Errors
/softwareonly
This argument is a filter switch and enables the user to view only the software
components needed for installation. When using this filter switch, you must
exit, and then restart HP SUM to return to an unfiltered state. Do not use the
/softwareonly argument with the /romonly argument.
/continue_on_error
This argument causes the installation to continue and ignore errors. Valid
values are
FailedDependencies.
The ServerNotFound option can be used to bypass inactive or unavailable
remote hosts when deploying firmware or software to multiple remote hosts at
the same time.
/override_existing_
connection
This argument defines the behavior when a remote target has an existing HP
SUM session in progress. This argument overrides the session in progress and
reinitializes the installation framework on the remote host.
/On_failed_dependency
This argument tells HPSUM how to proceed when a component has a failed
dependency.
The default of OmitHost causes the host to be put in a failure state and no
install is attempted on it.
OmitComponent deselects the affected component(s) and proceeds with any
updates that do not have dependency failures.
Force attempts all updates, even if they have dependency failures.
Reboot Options
/r[eboot]
If the following conditions are met, then this argument causes the server (or
host server in a remote installation) to reboot:
•
The /reboot option is selected or given as a command-line argument.
•
All components selected for installation are successfully installed.
•
At least one of the installed components requires a reboot to complete its
installation.