HP DreamColor Z27x Professional Display - Manual (Page 9)

1 Product Features
HP Z27x Monitor
The LCD (liquid crystal display) monitor has an active matrix, thin-film transistor (TFT) panel. The
monitor features include:
● 68.58 cm (27-inch) diagonal viewable area display with 2560 x 1440 resolution, plus full-screen
support for lower resolutions; includes custom scaling to support 4096×2160 or 3840×2160
resolutions using a variety of presentation methods
● Wide color gamut to provide 100% coverage of both AdobeRGB and sRGB color spaces and
98% of DCI-P3
● Ability to accurately remap the color gamut of the monitor (within the supported color gamut of
the panel) to enable the selection of the color space and very accurately set the RGB primaries
for consistent and repeatable colors
● Very high color and luminance stability (with typical use)
● Calibrated color space factory presets for sRGB, AdobeRGB, DCI-P3, BT.709, BT.601, and
BT-2020 so the monitor is ready to use for color critical applications with minimal setup
● Re-calibrateable color presets that allow you to re-calibrate to a standard or custom color space
by specifying the color primaries, white point, gamma, and luminance (requires the separately
purchased HP DreamColor Calibration Solution kit)
● Option to return to Factory Calibration settings or User Calibration settings to easily restore the
monitor to the factory or user settings
● User calibration that requires the DreamColor calibration solution kit (sold separately) or a third-
party measurement device
● Built-in support for the Klein K10-A Photo Research PR-6xx, 7xx series, and Konica Minolta
CA-310 measurement devices
● Updatable monitor firmware to enable HP to quickly and easily provide solutions to identified
problems and provide custom solutions
● Four reconfigurable front bezel Function buttons to quickly select the most commonly used
operations
● Wide viewing angle to allow viewing from a sitting or standing position, or moving from side-to-
side
● Adjustable tilt, height, swivel, and pivot capabilities
● Removable stand for flexible monitor panel mounting solutions
● HP Quick Release 2 to quickly install the monitor on the stand with a simple click and remove it
with the convenient sliding tab release
● Optional thin client mounting bracket that attaches to the rear of the stand (purchased
separately)
● 40mm x 40mm VESA standard mounting holes on rear panel for mounting an external device
● Easy access pull-out information card with the information needed when contacting HP support
HP Z27x Monitor 1