HP DreamColor Z27x Professional Display - Manual (Page 47)

two options require that a specific function be mapped to one of the four bezel function buttons. Refer
to
Changing the Bezel Button Functions on page 40 for information on mapping the bezel function
buttons. The following sections describe the usage of these two options.
Next 4K Corner
When viewing a 4K source as pixel-for-pixel, press the Next 4K Corner button to move, in order,
between the following five positions:
● Center of the frame
● Top left corner
● Top right corner
● Bottom left corner
● Bottom right corner
The image will continue to switch between the five positions for each button press until Pixel-for-Pixel
display is disabled.
Scroll 4K Region
When viewing a 4K source as pixel-for-pixel, press the Scroll 4K Region button to display navigation
arrows, allowing you to move around the frame to the desired area.
Using Picture-in-Picture (PIP) and Picture-beside-Picture
(PBP)
The monitor supports both PIP, where one source is overlaid over another, and PBP, where one
source is positioned adjacent to one another either horizontally (for landscape orientation) or vertically
(for portrait orientation).
To use PIP or PBP:
1. Connect a secondary input source to the monitor.
2. Press one of the five front bezel buttons to activate the buttons, and then press the bottom Open
Menu button to open the OSD.
3. In the OSD, select PIP Control > PIP On/Off and then select either Picture-in-Picture or
Picture-beside-Picture.
4. The monitor will scan the secondary inputs for a valid input and use that input for the PIP/PBP
picture. If you want to change the PIP/PBP input, select PIP Input in the OSD and select the
desired input (DisplayPort 1, DisplayPort 2, or HDMI).
5. If you want to change the size of the PIP, select PIP Size in the OSD then select either Enlarge,
Reduce, Set to Maximum Size, Set to Minimum Size, or Reset to Default Size. At maximum
size, the PIP will display pixel-for-pixel all input formats up to 2048 × 1080. This is to facilitate
using the PIP as a confidence monitor. Please refer to the following section for more information
on this usage.
6. If you want to adjust the position of the PIP, select PIP Position in the OSD, then select either
Top Left, Top Right, Bottom Left, Bottom Right, or Fine Tune Position.
Using Picture-in-Picture (PIP) and Picture-beside-Picture (PBP) 39