HP ProLiant DL360e Gen8 Server - Manual (Page 63)

Hardware options installation 63
11. Connect the GPU power cable to the system board (" System board components " on page 9 ):
12. Install the access panel (on page 19 ).
13. Install the server into the rack (" Installing the server into the rack " on page 26 ).
14. Power up the server (on page 16 ).
HP Trusted Platform Module option
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website (
http://www.hp.com/go/productbulletin ).
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
1. Installing the Trusted Platform Module board (on page 64 ).
2. Retaining the recovery key/password (on page 65 ).
3. Enabling the Trusted Platform Module (on page 66 ).
Enabling the TPM requires accessing RBSU (" HP ROM-Based Setup Utility " on page 81 ). For more
information about RBSU, see the HP website ( http://www.hp.com/support/rbsu ).
TPM installation requires the use of drive encryption technology, such as the Microsoft Windows BitLocker
Drive Encryption feature. For more information on BitLocker, see the Microsoft website
( http://www.microsoft.com ).
CAUTION: Always observe the guidelines in this document. Failure to follow these guidelines
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
• Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
• When installing or replacing hardware, HP service providers cannot enable the TPM or the encryption
technology. For security reasons, only the customer can enable these features.
• When returning a system board for service replacement, do not remove the TPM from the system board.
When requested, HP Service provides a TPM with the spare system board.