HP LaserJet 6pmp Printer series - Manual (Page 63)

Printing on Envelopes
Before you load envelopes in Tray 1,
make sure they are undamaged and are
not stuck together.
C a u t i o n
Never use envelopes with clasps, snaps,
windows, coated linings, self-stick
adhesives, or other synthetic materials.
See Appendix B for media specifications.
1 Grasp Tray 1 by the two finger tabs
and pull the top down. Pull out the
plastic tray extender with the center
finger tab.
2 Open the rear output tray by grasping
the center finger tab and pulling the top
down. Pull out the tray extender until it
snaps into place. (This reduces
envelope curling.)
3 Place envelopes against the left side
of the tray, print-side up, with the
postage-end in. Slide the envelopes
into the printer as far as they will go
without forcing them.
4 Slide the paper width guide to the left
until it lightly touches the right side
of the envelope stack.
5 Make sure the envelopes fit under the
plastic tabs on the paper width guide
and the left side of the tray.
3-12 Printing Tasks
EN