HP LaserJet 6pmp Printer series - Manual (Page 128)

6 Remove the SIMM from the antistatic
package while avoiding touching the
metal contacts.
7 Hold the SIMM so the notch on one
end is on the bottom and the metal
contacts face toward the slot.
8 Hold the SIMM at a 30 degree angle
to the first available slot from the
right. Push the edge of the board
evenly and firmly into the slot (
D ).
Rotate the SIMM to the right ( E ) until
the board snaps into the locking tabs.
Repeat steps 6, 7, and 8 for each
SIMM being installed.
9 Replace the side panel by lining up
the alignment arrows (
F ) and sliding
the panel backwards ( G ) until the
release button latches into place ( H ).
Close the top cover.
10 Reinstall the interface cable(s) and
power cord. Turn the printer on.
Continue on the following page.
D
Memor
y
Insta
llat
ion
EN
Memory Installation D-3