HP LaserJet 6pmp Printer series - Manual (Page 21)

Step 7. Attach the Power Cord
1 Locate the power On/Off button on
the right side of the printer. Make
sure the power is not On (button
should be in the out position).
2 Open the power cord door at the
back/right corner of the printer using
the finger tab for leverage.
3 Connect the power cord securely to
the printer. Close the power cord
door, while allowing the power cord
to feed through the hole in the door.
Connect the other end of the power
cord to a grounded power strip or a
power outlet.
4 Switch the printer on by pressing the
On/Off button.
N o t e
Before printing you must install printer
software. Go to
Step 8. Install Printer
Software on the following page.
1-12 Printer Setup
EN