HP 3PAR Application Software Suite for Oracle - Manual (Page 27)

If you are not using the backup server as the NetBackup master server, be sure to install Recovery
Manager for Oracle on the NetBackup master server.
CAUTION: Before you upgrade to a new version of 3PAR Recovery Manager, deinstall any
previously installed versions of Recovery Manager. To remove a previously installed package, log
on as the root user and use the pkgrm command. For versions prior to, or
equal to, 3.0.4, the package name is VCDBAora. Starting with version 4.1.0, the package name
is RMOra.
Starting Installation
To install 3PAR Recovery Manager on a Solaris system:
Procedure 1
1. Log on as the root user.
2. Insert the 3PAR Recovery Manager CD into a CD-ROM drive.
If the CD is not mounted automatically, you will need to mount it manually.
# mount -F hsfs -o ro /dev/dsk/c0t6d0s2/cdrom
3. Change to the CD-ROM drive.
# cd /cdrom/cdrom0/Solaris
4. Use the pkgadd command as follows:
# pkgadd -d . RMOra
You will be prompted to answer several questions about creating the installation area and the
setuid
files to be installed.
NOTE: Install the following patch if applicable:
•
Solaris 5.10 requires patch 119130-26, or higher.
The following command can be used to verify whether the patches are installed or not:
•
showrev -p | grep 119130
Verifying Installation
To verify 3PAR Recovery Manager installation on a Solaris system:
1.
Log in as the root user.
2. Use the pkginfo command as follows:
# pkginfo -l RMOra
PKGINST: RMOra
NAME: HP 3PAR Recovery Manager Software for Oracle on Solaris
CATEGORY: application
ARCH: Sparc
VERSION: 4.2.0.10
BASEDIR: /opt/3PAR/RMOra
VENDOR: Hewlett-Packard Development Company
DESC: HP 3PAR Recovery Manager Software for Oracle on Solaris
PSTAMP: RMOra-4.2.0:03-26-2012_19:09:48
Installing Recovery Manager on Solaris Systems 27