HP IO Accelerator for BladeSystem c-Class User Manual
Page 37
Upgrading devices 37
b.
Run the fio-bugreport command-line utility and save the output. This output captures the device
information for each device in the system. This device information will be useful in troubleshooting
any upgrade issues. For example:
fio-bugreport
c.
Detach the IO Accelerator devices. For example:
fio-detach /dev/fct*
For more information, see "fio-detach (on page
)."
2.
Unload the current IO Accelerator driver. For example:
$ pfexec rem_drv iomemory-vsl
3.
Uninstall the 2.x HP IO Accelerator VSL software:
$ pfexec pkgrm iomemory-vsl
4.
Install the new VSL and related packages:
a.
Download the IO Accelerator VSL package and supporting packages from the HP website
b.
Uncompress the package:
$ gunzip -c iomemory-vsl*pkg.tar.gz|tar -xf -
c.
Install the VSL and utilities using the following command:
$ pfexec pkgadd -d . iomemory-vsl
5.
Update the firmware on each device to the latest version using the fio-update-iodrive command.
CAUTION:
Do not turn off the power during a firmware upgrade, because this might cause
device failure. If a UPS is not in place, consider adding one to the system before performing a
firmware upgrade.
Sample syntax:
fio-update-iodrive [options]
Where
the devices to the selected firmware. See the utility reference for more options If you want to update
specific devices.
6.
Reboot the system.
A warning that the upgraded devices are missing a lebmap, if fio-status is run. This is a customary
warning, and the issue will be corrected in the next step.
7.
Load the VSL. For example:
$ modprobe iomemory-vsl
For more information, see "Loading the IO Accelerator driver ("
Loading the IO Accelerator VSL facility
" on page
)."
CAUTION:
Use this utility with care since it deletes all user information on the IO Accelerator.
8.
Using the fio-format command, format each device. For example:
fio-format
You are prompted to confirm you want to erase all data on the device. The format might take an
extended period of time, depending on the wear on the device.
9.
Attach all IO Accelerator devices using the following command:
fio-attach /dev/fct*