HP Coarse Wave Division Multiplexer - Manual (Page 22)

3. Slide the CWDM (SFP) transceiver out of the device module slot.
NOTE:
If your CWDM (SFP) transceiver does not slide easily from the module slot, use a gentle
side-to-side rocking motion while firmly pulling the CWDM (SFP) transceiver out.
4. Put the dust covers securely on the CWDM (SFP) transceivers.
Cabling HP CWDM MUX modules
Connecting fiber optic cables from the HP CWDM MUX module ports to the CWDM (SFP) transceivers is
simplified by color coding. See Table 2 for the color-coded labels and their corresponding wavelength
connectors.
Figure 13 shows how to connect cables from the CWDM (SFP) transceiver to the equipment ports on
a HP CWDM MUX module.
To connect fiber optic cables from the CWDM (SFP) transceiver to the HP CWDM MUX module:
1. Clean all fiber optic connectors on the cable before inserting them into the HP CWDM MUX module.
2. Connect one end of the fiber optic cable to the HP CWDM MUX module connector and connect
the other end of the fiber optic cable to the corresponding CWDM (SFP) transceiver installed on
the FC or network device.
NOTE:
Consult your network planning diagram to map the fiber optic cables to the CWDM (SFP)
transceivers and equipment ports on the HP CWDM MUX modules.
Table 2 HP CWDM MUX and CWDM (SFP) transceiver color codes
Label color Connector (Wavelength) Description
Gray Longwave 1470 nm single-mode.
Violet Longwave 1490 nm single-mode.
Blue Longwave 1510 nm single-mode.
Green Longwave 1530 nm single-mode.
Yellow Longwave 1550 nm single-mode.
Orange Longwave 1570 nm single-mode.
Red Longwave 1590 nm single-mode.
Brown Longwave 1610 nm single-mode.
22 Installing HP CWDM MUX modules