HP Coarse Wave Division Multiplexer - Manual (Page 21)

• To clean contaminants from the optical bores of a CWDM (SFP) transceiver, use lint-free 1.25 mm
Fiber Optic swabs to clean the ferrules of the optical connector.
• Dispose of this product according to all national laws and regulations.
NOTE:
Dry cleaning is the preferred method. Using alcohol-based cleaning swabs may cause problems.
WARNING!
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into an
optical fiber or connector port. Always assume that fiber optic cables are connected to a light source.
Inserting a CWDM (SFP) transceiver
To insert a CWDM (SFP) transceiver:
1. Verify that the CWDM (SFP) transceiver is the correct model for your application.
2. Grasp either side of the CWDM (SFP) transceiver with your thumb and forefinger.
3. Insert the CWDM (SFP) transceiver into the slot on the front panel of the FC or network device
( Figure 12 ). You should hear a clicking sound when you have properly seated the CWDM (SFP)
transceiver.
Figure 12 Inserting the CWDM transceiver
Removing a CWDM (SFP) transceiver
To remove a CWDM (SFP) transceiver:
1. Disconnect the fiber cable from the CWDM (SFP) transceiver.
2. Lower and pull the bail.
CWDM MUX user guide 21