Lifting the tv, Attaching or removing the stand, Lifting the tv attaching or removing the stand – HP LT4200 42 inch Professional LCD HDTV User Manual
Page 18: Attaching or removing
8
HP HDTV User’s Guide
Lifting the TV
The TV is heavy; be sure to use ergonomically correct
lifting procedures when moving the TV.
Due to the size and weight of the TV, it is recommended
that a minimum of two people move it.
To transport the TV, grasp the left and right ends of the
panel in the areas below and above the screen. Do not
lift the TV by the attached stand.
Move the TV gently. Never place the TV with the
glass screen facing downward, unless it is protected
with pads.
Attaching or removing the stand
Your HP HDTV comes with the stand attached. Select
TV models come with a stand that must be attached to
the display. Reverse these steps to remove the stand.
Before attaching the stand, unplug the AC power cord
from the AC power outlet, and remove any cabling.
1
Locate the TV stand (two pieces), the TV panel,
and the eight screws of mounting hardware from
the box.
2
Using the two pieces of the stand, place the
pedestal onto the base, and press down on the
pedestal to insert it into the base.
3
Turn the assembled stand over and insert four short
screws into the bottom of the base, and tighten the
screws to secure the base to the pedestal.
4
Carefully place the TV panel with the glass screen
facing downward on a padded, stable table.
Position the bottom of the TV panel near the edge
of the table.
CAUTION: Use two people to assemble
the TV.