HP LD4245tm 41.92-inch Interactive LED Digital Signage Display - Manual (Page 48)

Picture ID
Picture ID is used to change the settings of a specific display using a single IR receiver for
multivision. Communication is possible between a set with an IR receiver and other sets using audio
cables. Each set is identified by a set ID. If you assign the Picture ID using the remote control, only
displays with the same Picture ID and Set ID can be controlled remotely.
1. Press the red ON button on the remote control
2. If you press the left/right buttons or press the ON button repeatedly, the Picture ID cycles
through OFF and 0 to 4. Assign the ID you want.
If you assign the Set ID to each set with multi-vision, and then assign the Picture ID using the
red button on the remote control, the key command is displayed for the set with the same Set ID
and Picture ID. A set with different Set IDs and Picture IDs cannot be controlled by IR signals.
NOTE: For example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be
controlled by IR signals.
For each set, you can change the settings for the PICTURE, AUDIO, TIME, NETWORK and MY
MEDIA menus or the hot keys on the remote control.
If you press the green OFF button for Picture IDs, the Picture IDs for all sets are turned off. If you
then press any button on the remote control, all sets will start working again.
Picture ID will be disabled while using the MY MEDIA menu.
38 Chapter 6 Customizing settings