HP OmniBook 800 Notebook PC - Manual (Page 25)

25
• To use an SRAM card, you must first load drivers for it. Refer to the online Help
for Windows 95.
End popup
To remove a PC card
Caution
Never remove an I/O card while an application is open that’s set up to use that
card. Exit the application first. If you remove the card, the application (or the
OmniBook) might behave unpredictably or stop responding until you restart
the OmniBook.
Never insert or remove a plug-in card while the PC card drive is actively
reading or writing data. Wait until the PC card drive is done. Otherwise, you
could lose data or the OmniBook could stop responding.
1. Click the PC card indicator in the taskbar, then click Stop.
This protects your data and avoids unexpected problems. You can restart the
card by removing it, then inserting again.
2. For a card in the upper card slot, slide the card-eject lever toward the end of the
case until the card pops out, then pull out the card.
–or–
For a card in the lower card slot, turn over the OmniBook, release the two
latches on the bottom of the slot tray, and pull out the tray.