Option d – test device name, Must b – HP Integrity NonStop H-Series User Manual
Page 16
NSPDIAG Operation
NSPDIAG User Guide — 529007-002
1 -8
Option D – Test Device Name
This is the default configuration, which allows NSPDIAG to communicate with
Atalla NSP through the Boxcar or ARM process interface.
6 - A6000 (Without IFM)
A discontinued model of Atalla NSP.
7 - A7000 (Without BOXCAR)
A discontinued model of Atalla NSP.
E - Ethernet (Without BOXCAR)
This configuration allows NSPDIAG to communicate with the Atalla NSP directly
without the Boxcar or ARM process interface. The IP address of the NSP must be
specified using
.
A - ASYNC
This configuration allows NSPDIAG to communicate with the Atalla NSP directly
via the Atalla NSP asynchronous interface. When this configuration is selected,
NSPDIAG opens the Atalla NSP exclusively.
S - SERVERCLASS_Send to ARM
This configuration allows NSPDIAG to communicate to ARM using
SERVERCLASS_SEND calls. This configuration prompts for the ARM server class
name.
Option D – Test Device Name
The device name depends on the device type and the I/O configuration. This option
must be selected before testing can begin. The default is no device name.
When the configuration is G, the device name is the ARM or Boxcar process name that
is managing the Atalla NSP.
When the configuration is E, the device name is the TCP/IP address of the Atalla NSP.
If you have configured the Atalla NSP to use a port number other than 7000 in the
CONFIG.PRM file, you must also use
Option O – TCP/UDP port number
to set the port
number.
When the configuration is A, it is the device name of the Atalla NSP.
When the configuration is S, the device name is the ARM pathway process name.
When -D is selected, the current device name is displayed and the prompt for the new
device name is displayed. After the name is changed, the I/O configuration is set to
default. If
was used to specify a batch file name prior to
setting the device name, the batch file name is deleted.
Note. You must set
to S and provide the ARM server
class name, then use
to specify the ARM pathmon
process name.