HP Integrity NonStop H-Series - Manual (Page 13)

NSPDIAG Operation
NSPDIAG User Guide — 529007-002
1 -5
Using Main Menu
Using Main Menu
At the TACL prompt type:
run NSPDIAG
The following menu is displayed:
Through the menu options, you specify the parameters or change the default values;
you then start testing commands by selecting:
•
Option I – Interactive Testing and then entering the test command on the screen,
or
Table 1-2. Main Menu Options
Command Description
? Help. Information on files and parameters
A View Log in Axx100 NSP
B Batch file name: ---
C I/O Configuration: G- A6000(IFM)/A7000(BOXCAR)/Ethernet(BOXCAR or
ARM)
D Test device name:
O TCP/UDP port number: (Default 7000)
F Data file name:
G Copy test commands from data file into memory: (Default is Off)
H Handle device : (Default is Ignore)
I Interactive testing
K Display character count for all messages: (Default is Off)
L Log file name:
M MFK name (don't check if blank):
R Repeat count for data file/diagnostic functions (0 = forever): (Default is 1)
S START TESTING DEVICE
T Timed repeat count: (Default is 0)
V Verbose mod, details all messages to screen and log: (Default is Off)
W I/O Timeout in seconds (0 = wait forever): (Default is 0).
X EXIT.
Enter letter of menu option: _____
Note. The default values for all the parameters are shown in the above menu.