HP StorageWorks 2.64 Director Switch - Manual (Page 29)

29 Embedded Web Server User Guide
2
Configuring the Product
This chapter describes how to configure an HP product using the EWS interface.
These procedures can be used to configure a product after installation and as
changes are needed. You can use the tabs of the Configure page to configure the
following aspects of a director or edge switch:
■ Factory Default Values , page 30
■ Configuring Ports , page 31
■ Configuring Product Identification , page 35
■ Configuring Date and Time , page 37
■ Configuring Operating Parameters , page 38
■ Configuring Fabric Parameters , page 41
■ Configuring Network Information , page 45
■ Configuring SNMP , page 47
■ Enabling or Disabling the CLI , page 49
■ Enabling or Disabling Host Control , page 50
■ Zoning Tab View , page 51
■ Configuring User Rights , page 52
■ Binding Ports to Devices , page 56
■ Configuring Open Trunking , page 74
■ Installing Feature Keys , page 77