HP StorageWorks 2.64 Director Switch - Manual (Page 47)

Configuring the Product
47 Embedded Web Server User Guide
Configuring SNMP
Note: The ability of the SNMP tab to configure SNMP depends on whether this
licensed feature is active on the product.
Perform this procedure to enable the SNMP agent, configure community names,
write authorizations, network addresses, and user datagram protocol (UDP) port
numbers for up to six SNMP trap message recipients. A trap recipient is a
management workstation that receives notification (through SNMP) if a switch
event occurs. To configure SNMP trap recipients:
1. Choose Configure from the navigation panel.
2. Choose the Management tab. The Management and SNMP tab views
display ( Figure 11 ).
Figure 11: Configure SNMP parameters tab view
a. Click the Enable SNMP Agent field to enable SNMP. Clear the check
box to disable the SNMP Agent.
b. Click the Enable Authorization Traps field to enable authorization trap
messages to be sent to SNMP management stations when unauthorized
stations try to access SNMP information from the product.