HP StorageWorks 2.64 Director Switch - Manual (Page 50)

Configuring the Product
50 Embedded Web Server User Guide
Enabling or Disabling Host Control
Perform this procedure to enable or disable host control of the product through the
OSMS.
The OSMS is a keyed feature that allows host control and inband management of
the director or switch through a management application that resides on an
open-systems interconnection (OSI) device. This device is attached to a director
or switch port. The device communicates with the switch or director through Fibre
Channel common transport (FC-CT) protocol.
The OSMS feature must be installed to access this control. Refer to “ Installing
Feature Keys ” on page 77 for instructions. If the feature is not installed, the
message Feature not installed displays. To enable or disable host
control:
1. Choose Configure from the navigation panel.
2. Choose the Management tab and the OSMS tab. The OSMS tab view
displays ( Figure 13 ).
Figure 13: Enabling OSMS host control
3. Perform one of the following steps as required:
a. Click Enable to activate the OSMS host control. The following message
displays:
Your changes to the host control enable
state have been successfully activated .
b. Click Disable to deactivate the OSMS host control. The following
message displays:
Your changes to the host control
enable state have been successfully activated .