HP StorageWorks 2.64 Director Switch - Manual (Page 31)

Configuring the Product
31 Embedded Web Server User Guide
Configuring Ports
Perform procedures in this section to configure names and operating
characteristics for Fibre Channel ports. To configure one or more ports:
1. If you are going to change the Speed parameter on a Director 2/64, set the
product offline as follows:
a. Choose Operations from the navigation panel. The Operations page
displays.
b. Click the Online State tab, then click Set Offline. The following message
displays:
Your operations changes have been
successfully activated .
2. At the EWS screen, choose Configure from the navigation panel. The
Configure page and the Ports tab view display ( Figure 4 ).
Note: Because the Director 2/140 has many ports, the listing of ports is divided into
separate displays, which are accessed by clicking the hyperlinks 1-31, 32-63, 64-95,
96-127, and 132-143. (Ports 128 through 131 are internal ports and not available
for external connections.) If you make any changes to a particular list of ports, click
Activate before selecting another list of ports. If you do not click Activate, changes are
not implemented on the director.