HP Integrity NonStop J-Series - Manual (Page 83)

Triggers
HP AutoSYNC User’s Guide—522580-017
6-3
TRIGGERONFILESET
If no archive name is found, AutoSYNC will pass the placeholder question mark
(?). For OSS, files the absolute pathname is specified.
Recovery files have a name chosen by AutoSYNC. Such files are usually purged
by AutoSYNC when the replacement file has been synchronized, but triggers may
preserve these files by renaming them
•
#MAPNAMES is replaced by the mapnames-file that is configured for the
syncfileset using the MAPNAMES option. If the MAPNAMES option is not
specified, AutoSYNC substitutes the placeholder question mark (?) for the
mapnames-file. This option is applicable to Guardian syncfilesets only.
TRIGGERONFILESET
TRIGGERONFILESET Arguments
•
#SOURCEFSET is replaced with the original source file set name.
•
#DESTFSET is replaced with the designating file set name.
•
#FSETCOUNT is the number of files in the source file set.
•
#SYNCCOUNT is the number of files replaced on the destination.
•
#COUNTNOTBKUP is the number of files not backed up.
•
#COUNTNOTREST is the number of files that were not restored.
Trigger Output
The TACL trigger command and the output of the TACL or OSS session are captured
in the log file:
•
For scheduled synchronizations, the log file is the MapDB file SLggguuu.
•
For a one-time synchronization, the user specifies the LOGFILE option in the
SYNCHRONIZE command.
Troubleshooting triggers
For problem resolution and debugging, you can run the trigger command on a terminal
at a TACL prompt.
If the destination is on a remote system, the user must have security privileges
sufficient to run a remote TACL process.
Note. If your triggers generate a lot of output, consider sending the output to a dedicated
trigger log file, which would be specified in the trigger macro, or simply increase the size of the
AutoSYNC log file, as instructed in paragraph
Managing the SLggguuu Log File on page A-2.