HP Integrity NonStop J-Series - Manual (Page 38)

Installation
HP AutoSYNC User’s Guide—522580-017
2-10
Running Different Versions of AutoSYNC
7. Optionally AUTHORIZE AutoSYNC. See section Authorize AutoSYNC above.
8. Use the ACTIVATE SYNCUSER command to activate the AutoSYNC users.
9. Use the STATUS SYNC command to ensure that synchronizations have been
activated.
Note that the same version of AutoSYNC must be running on the source and
destination systems. Updates to the software should be planned accordingly.
Running Different Versions of AutoSYNC
If you need to run different versions of AutoSYNC on the same system, for example to
test a new version of the product, you must configure an alternate AutoSYNC
environment (Monitor and MapDB) and install the test software in a different location.
For details on configuring and using an alternate environment, see
Configuring and
Using an Alternate AutoSYNC Environment on page A-7