HP Designjet 10000s Printer series - Manual (Page 296)

Parameters: value in mm
Unstick mode (UNSTICK MODE)
Use this option to execute the media peel sequence to unstick media when printing starts.
Parameters:
● OFF — Does not execute the unstick sequence.
● ON — Executes the unstick sequence.
Printhead rest period (PH REST PERIOD)
Use this option to define the number of passes the printhead carriage performs before it pauses for the
selected media type.
Parameters:
● CYCLES — Number of passes
Printhead rest time (PH REST TIME)
Use this option to define the amount of time the printing carriage will pause between passes for the selected
media type.
Parameters:
● TIME — Time in minutes and seconds
Printhead temperature rest (PH TEMP REST)
Use this option if you want printing to pause if there is a gap between the set temperature of the media print
heater and the printhead temperature is too high.
286 Chapter 14 Tell me about front panel menus ENWW
Tell
me ab
ou
t f
ron
t
pan
el
menu
s