HP Designjet 10000s Printer series - Manual (Page 137)

Remove dual rolls media edge guards for full width media
printing
If you want to use full width media, 104 in. (2641 mm), you must first remove the media edge guards used
for dual roll media printing.
NOTE The guards can be left in place for any media of a width of 102 in. (2590 mm) or less.
1. Remove the two screws (3) that attach the edge guard (1) to the slider (2) in the rail of the platen.
2. Loosen the front two screws (2) and lift the of rear of the edge guard (1) so its front slider can be
removed from the front mounting rail of the platen, leaving the rear slider (3) in the rear rail.
ENWW Remove dual rolls media edge guards for full width media printing 127
How do
I use dual medi
a
rolls?