HP Designjet 10000s Printer series - Manual (Page 140)

130 cm (51 inches) of media wastage at the start of the print job and 80 cm (31.5 inches) of wastage
at the end of the job.
● You are working in an area with limited access or the with media rolls that are very heavy meaning
handling must be minimized.
For this type of print job the best type of double-sided printing to choose is Printing on the back of the
media from the take-up reel (without relocating from take-up side) because due to length of media
used the risks of image degradation caused by scratches to the top side during the rewind process is
increased. The relative amount of media waste is also reduced to an acceptable level when compared
to the much greater length of media used for the total print job. This method requires approximately
30 cm (12 inches) of media wastage at the start of the print job and 180 cm (71 inches) of wastage at
the end of the job.
130 Chapter 4 How do I perform double-sided printing ENWW
How
do
I per
fo
rm
do
ub
le-si
d
ed
p
rint
in
g