HP XP LUN Configuration and Security Manager Software - Manual (Page 20)

20 LUN Manager for the XP10000/XP12000
NOTE: Storage partition administrators can display information or operate only within the allocated SLPR.
For more information about SLPRs, see the HP StorageWorks XP Disk/Cache Partition User Guide.
Figure 7 LUN Manager pane
LUN Manager pane
The LUN Manager pane contains the tabs listed in Table 5 .
LU Path tree
The LU Path tree on the upper left of the LUN Manager tab lists Fibre Channel ports in the disk array and
hosts connected to them. Hosts are identified by nicknames and WWNs and are classified by host groups.
The LU Path tree may contain different folders: Fibre Channel, and so on.
Fibre Channel folder
The following Fibre Channel port icons are used in the LU Path tree:
Table 5 LUN Manager tabs
Tab Use this tab to...
LUN Manager Define LU paths and apply LUN security for logical volumes.
Port Configure ports by setting the topology and port addresses (” Starting Port
Operations” on page 31 ).
Table 6 Fibre Channel port icons for LUN Manager operations
Icon Status
A short-wave port in standard mode without LUN security
A short-wave port in standard mode with LUN security
A long-wave port in standard mode without LUN security
A long-wave port in standard mode with LUN security
A short-wave port in high-speed mode without LUN security