HP ProLiant DL360 G4 Server - Manual (Page 21)

Post-installation tasks for HP ProLiant 300 series servers only 21
Installing the Network Teaming and Configuration
Utility
The CPQTEAM Utility enables multiple NICs to be teamed together. You must run the HP Software update
manager to install the CPQTEAM utility.
During the CPQTEAM software installation process, a message might appear, stating that the CPQTEAM.DLL
file is needed. A default path appears in the message box. Click OK to accept the path and continue with the
installation.
Using HP Software Update Manager (HPSUM)
The HPSUM for the operating system is automatically installed when the server software is installed. This
software contains device drivers and utilities that take advantage of specific capabilities offered with ProLiant
server products. These drivers are provided for use with ProLiant hardware only.
1. Do one of the following to launch HPSUM:
a. For Microsoft Windows Small Business Server 2011 Standard/Microsoft Windows Small Business
Server 2011 Essentials, click Start, and then select All Programs>Pre-install Features>HP Service
Pack for ProLiant.
b. For Microsoft Windows Server 2012 Essentials, press the Windows key from the keyboard, then
right-click anywhere in the Start page, and then click All Apps>Pre-Install Features>HP Service Pack
for ProLiant.
2. Follow the on-screen instructions when the setup program is launched.
To manually launch the setup program:
1. Click Start>Run.
2. Enter the following path in the textbox:
C:\HPSUM\SETUPEX.EXE
3. Click OK.
4. After the setup program is launched, follow the on-screen instructions.
Configuring array controllers
If an array controller has been purchased with the server, run the online ACU to set up the remaining physical
drives for use.
IMPORTANT: Microsoft® Internet Explorer is required to run the ACU. Internet Explorer is used
to interface with the array controller. For the page to display properly, the server IP address must
be included in the trusted sites list. Internet Explorer must be restarted after adding the IP address
to the trusted sites list for the settings to take effect.
1. Do one of the following to configure array controllers:
a. For Microsoft Windows Small Business Server 2011 Standard/Microsoft Windows Small Business
Server 2011 Essentials, click Start, and then select All Programs>HP System Tools>HP Array
Configuration Utility.