HP Designjet 2500.3500cp Printer series - Manual (Page 250)

Troubleshooting
Solving Media-Handling Problems
11-30
The Cutter is Jammed
n Switch the printer off.
n Open the window.
n With you finger and thumb carefully pinch together the cutter assembly plates
(1) and move it to the left (2).
n If the paper needs to be removed from the printer because it is damaged, perform
part of the procedure described on page 3-30, Removing a Roll from the Printer.
A Sheet is Ejected when You Switch On the Printer
n The printer is doing an automatic calibration check. Wait for the STATUS /
Ready message and then reload the sheet.
1
2
C472378