HP ProLiant DL140 G3 Server - Manual (Page 42)

Network operating system (NOS) installation 42
Section 2. Customizing the installation
Language Selection
Select the language of choice you prefer for the installation, then click Next to continue.
Keyboard Configuration
Your HP server comes with a generic 104-key PC keyboard.
After selecting the appropriate option for the keyboard layout type, click Next to continue.
Disk Partitioning Setup
HP recommends selecting the automatic partitioning mode.
1.
Click Automatically partition to continue.
2. Remove all system partitions, then select a hard drive.
3. Click Next to continue.
4. If a Warning dialog box appears, click Yes to continue.
5. In the Partitioning dialog box, click Next.
6. Review the Disk Setup settings and modify them if necessary, then click Next.
Boot Loader Configuration
HP recommends keeping the default option, then click Next to continue.
Network Configuration
Review the Network Configuration settings and see to it that they fit your environment, then click Next to
continue.
Firewall Configuration
Review the Firewall Configuration settings and modify them if necessary, then click Next to continue.
Additional Language Support
Review the Additional Language Support setting and modify it if necessary, then click Next to continue.
Time Zone Selection
Review the Time Zone Selection setting and modify it if necessary, then click Next to continue.
Set Root Password
Enter a root password consisting of at least six alphanumeric characters, then click Next to continue.
Package Defaults
Review the software selection and modify it if necessary, then click Next to continue.
Package Group Selection
Review and modify the selection if necessary, then click Next to continue.
If you selected the Custom install option, pre-determined packages have already been selected. However,
depending upon your network environment additional packages may be necessary.
NOTE: Remember to select appropriate package groups that match your network settings (e.g. The DNS Name
Server package may be required if you have set up your new server to be the DNS controller.).